My latest creation...a homemade earring holder!
This little project was quick, cheap, and super easy...and the result is a nice touch of decoration for my room!
Supplies:
Wire mesh grease splatter guard - bought mine for €1.20
Ribbon - €0.75
Scissors
Screwdriver
Lighter
Process:
- Using the screwdriver (or other tool depending upon the splatter guard you have), remove the handle of the splatter guard.
- Poke two SMALL holes in the mesh near the edges from which you would like the ribbon to extend (using either the screwdriver or the scissors).
- Cut 2 pieces of ribbon to desired length.
- Use the lighter to slightly burn one end of each ribbon so it is easier to fit through the small hole you have made in the wire.
- Thread one piece of the ribbon through either hole.
- Use the lighter to adhere the burnt end of the ribbon to the backside of the ribbon...I suppose you could also sew or glue the two pieces together.
- Tie the two pieces of ribbon into a bow.
- Hang on wall.
- Hang earrings and admire your new earring holder!
TA-DAHH! No more digging through your jewelry box to find the right pair! Enjoy :)
0 comments:
Post a Comment